65intheBurg
New User
I am installing a new clutch disk and bearings with the existing clutch assembly into my 5610. The disk is a 12" single stage clutch with 25 splines. When I installed the clutch assembly onto the disk/flywheel there is a gap where the spacers used to be. I dont remember removing the spacers during disassembly and they are no where to be found so I am thinking they were not there before.
My question is can I go ahead and bolt up the assembly to the flywheel without the spacers? I need to run through my photos to see if I have a pic of the clutch before disassembly.
My question is can I go ahead and bolt up the assembly to the flywheel without the spacers? I need to run through my photos to see if I have a pic of the clutch before disassembly.