(800) 853-2651
SHOP NOW

Super 55 PTO repair

super 55

super 55

Well-known Member
Location
Whonnock BC
I "Z" split my Super 55 to replace the PTO clutch discs and install new seals a few months ago and just now putting it back together. I have the original repair manual and parts manual, but I can not find where
it mentions where part 100684A, snap ring installs. Logically it looks like it should clip onto the PTO drive pinion shaft, to keep the clutch release bearing on the clutch release tube. Just want some
confirmation before I button it back up.
picture of C clip installation
 
I think I may have it figured out. I couldn't figure out why it wasn't mentioned in the repair manual in reference to the PTO repair and "Z" split. I believe that clip is suppose to go on the other side of the clutch, to hold the pilot bearing in place. I looked up clutch servicing in the the shop manual. In later tractors it looks like there were two clips held in by cap screws that replaced the "C" clip. The mystery is, how did my clip get on the backside of the clutch and onto the PTO pinion gear? I had the engine rebuilt and new clutch installed a few years ago, and I am wondering if that's when it happened? Looks like now I'll have to remove the clutch and hunt down a clutch alignment tool to reassemble it.
 
You must log in or register to reply here.

Similar threads

8
super 55 pto
Replies
13
Views
1K
super 55
super 55
M
Oliver Super 55 Diesel Cracked Head and PTO Clutch
Replies
17
Views
777
magnumpowers
M
R
Oliver Super 55 PTO
Replies
5
Views
307
I550
I
M
specs for Case 440 PTO clutch plates
Replies
4
Views
267
mushertoo
M
P
2520 PTO Clutch Release Bearing
Replies
4
Views
280
Tech 7
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top