Been awhile since I have been on here. I replaced my 49 8N manifold with one from yesterdays tractors. There isn't enough
clearance between the nut and the manifold on the end nuts to get a socket on. Even a thin wall socket. Also the mounting holes
for the bolts was enough off that I had to use a rubber mallet to make it go on. The manifold is "thicker" an wont let the air
tube for carb to line up. I talked to a very nice woman at yesterdays tractor an she said they haven't had this come up before.
They are sending me another manifold. My question is anyone here had this happen to them?
clearance between the nut and the manifold on the end nuts to get a socket on. Even a thin wall socket. Also the mounting holes
for the bolts was enough off that I had to use a rubber mallet to make it go on. The manifold is "thicker" an wont let the air
tube for carb to line up. I talked to a very nice woman at yesterdays tractor an she said they haven't had this come up before.
They are sending me another manifold. My question is anyone here had this happen to them?