Was attempting to do the rear axle seals and brake pads on 47 8n.
Backed off the adjustment screw thru tiny hole in back plate.
Removed the screws to hub and pulled.
Got 1/4" and stopped.
Pushed it back and pulled again and nothing. 1/4" and stopped again.
Took dead blow hammer and beat the crap out of the drum and backing plate.
Nothing.
Looking at 4 nuts holding brake assembly to axle housing.
Can it be removed as 1 piece and taken apart that way?
Backed off the adjustment screw thru tiny hole in back plate.
Removed the screws to hub and pulled.
Got 1/4" and stopped.
Pushed it back and pulled again and nothing. 1/4" and stopped again.
Took dead blow hammer and beat the crap out of the drum and backing plate.
Nothing.
Looking at 4 nuts holding brake assembly to axle housing.
Can it be removed as 1 piece and taken apart that way?