Water Pump for 8N

ThundermanND · Jun 28, 2020

Gentlemen, I have a water pump that fits Ford tractors 9N-2N-8N from 1932-1952. The Tisco number is CDPN8501A. I purchased it new from Fargo Tractor in Fargo, ND and opened the box but never installed it on my tractor. Sometime before I had time to install it on my 8N (which I found out before I installed it the existing pump was fine) I decided to sell the tractor because we sold the farm. Now I would like to sell the pump because I have no use for it and it's too light for a boat anchor.. I paid $56.00 for it and if someone out there has a need for it, I'll make them a deal.

call my cell phone 701-261-1956. Thanks guys.

Alden Sprecher
Mapleton, ND

>

Bruce(VA) · Jun 28, 2020

Suggestion........

A lot of the new pumps are too thick in the casting by the bolt holes and require that the studs be replaced. If this is an older model w/ the correct casting thickness, it will likely sell quicker.

Measure the thickness of the casting at the bolt holes and post the the results.
75 Tips

ThundermanND · Jun 28, 2020

Thanks for the note Bruce. The thickness of the pump casting at the bolt holes is 13/32". Add for the thickness of the bottom plate on the pump 1/8" making the total thickness at the mounting holes 17/32". Great information Bruce, thanks for the tip.

PopsH · Jun 28, 2020

Alden, I'll buy the pump if you can hold onto it until I get up to your part of the country, before December.

PopsH

ThundermanND · Jun 28, 2020

Hopefully it's gone by then but if not, I'll even Christmas wrap it for you. LOL

ThundermanND · Jun 29, 2020

Where you live Pop...

Water Pump for 8N

ThundermanND

Member

Bruce(VA)

Member

ThundermanND

Member

PopsH

Member

ThundermanND

Member

ThundermanND

Member

Similar threads