just a simple little question, since I have all the time in the world right now, the rear blade that I use for snow removal, I know its not that time of year, blade guard for the blade to prevent it from marking up cement drive ways, is there anything on the market or can a person make their own, looking for ideas, open to anything. Thanks.
I would think some PVC pipe with a groove cut out would slide over the blade and protect the concrete. you could bungee cord the pipe to the blade by drilling some holes in the back portion of the pipe. It wouldn't last a very long time but depending upon how often you need it and how big your driveway is, it could last a season. Here in VA it might last two or three years. Especially with this years snow count. Zero inches.
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.