G1000 wiring

Curt Cooke · Apr 17, 2020

I don't suppose anyone has a wiring diagram for this beast they would be willing to scan or fax to me? Or point me to a site where I could print one/
Curt

molinegb · Apr 17, 2020

What area do you need? Just built a new wiring harness for Jet3 Industrial. Should be same. I used 670S shematic.

Curt Cooke · Apr 17, 2020

There's a 4 bay connector to the rear of the machine. I have it figured out where they all go but one. A black wire disappears under the 3 pt. lift cylinder and the crud is so thick and heavy I can't quite figure just where it was headed. It may have just gone to an auxiliary jack but I'd feel better knowing.
Thanks,
Curt

Cowpuncher · Apr 17, 2020

(quoted from post at 16:51:36 04/17/20) I don't suppose anyone has a wiring diagram for this beast they would be willing to scan or fax to me? Or point me to a site where I could print one/ Is yours a G1000 or a G1000 Vista? I believe the wiring is the same. I have the G100 Vista repair manual for mine, and it has possible several pages and part numbers and partial schematic for the instrument panel and a good one for the lights on the tractor. I have a starter to put in my 1086, but could perhaps fax the pages to you this evening if your are interested. Other wise, you could call the Floyd County Museum in Charles City Ia. and they might have a wiring schematic to send you. (they are the depository for MM and Oliver materials) Their number is: 641-228-1099.

larry Mi · Apr 17, 2020

molinegb · Apr 17, 2020

Am thinking black wire is for the implement socket. The one usually gone or not hooked up.

ChrisQ · Apr 17, 2020

Wire would either go to the implement socket or transmission line pump oil pressure sender for the idiot light on the dash if it has one like the G900's.

G1000 wiring

Curt Cooke

Member

molinegb

Well-known Member

Curt Cooke

Member

Cowpuncher

Member

larry Mi

Member

molinegb

Well-known Member

ChrisQ

Member

Similar threads