(800) 853-2651
SHOP NOW

Shep Va

J

Josh in MI

Member
Hey, I have been very interested in your M5/3.9 Cummins project. I think your Cummins Olivers are great and visited your site many times in the past.

I understand it is a busy time of year, but I would love to see some pictures of the progress of this animal like you did with the Ollie's

Keep the green and yellow ones dirty!
 
The M-5 project kinda got delayed. I have most all the parts laying in the shop including the engine to make the conversion, but I just have not had time. I am hoping to get that project finished over the winter and paint it all this spring in time to use it some this spring. I will take some pictures as it comes togeather, I have already reworked that leaning seat and have replumbed the hydraulic filter with a spin on filter and a dipstick to check the fluid easier. I also reworked the drawbar and hitch so that it sits up with a standard streight drawbar with an offset on the end like every other normal tractor has.

This should be an exciting conversion, I have never done a Cummins conversion with a structural engine tractor before, this should be interesting. I will get some pictures as it goes.

I was really hoping to have it ready for next weekend to go to PA for the National Moline show, but I guess I will have to take another Moline up there. See you guys next weekend in PA.
 
Sorry, my site went down and died, and I have not had any time to think about rebuilding it. We are in the middle of corn and soybean harvest right now and I am getting things run togeather to go to PA to the moline show end of this week.

I will try to post some pictures of the M-5 project in a few weeks. I have a G-1050 I am pulling a cab off of right now and making it an open station and I have to get it done first as it is in the way of the M-5 in the shop. Too many projects :)

I will get some pictures up as I can.

Thanks
 
You must log in or register to reply here.

Similar threads

N
New Tires
Replies
12
Views
744
Fordfarmer
F
P
2520 PTO Clutch Release Bearing
Replies
4
Views
288
Tech 7
T
D
a 49 8N and a newbie owner
2
Replies
21
Views
2K
DaveZ (CA us)
D
O
4450 electrical gremlins.
Replies
5
Views
663
oliverkid
O
Steve in IL
CaseIH CX100 Opinions
Replies
2
Views
205
urbancase
urbancase
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top