I just bought a 1972 MF 175. I am rebuilding the power
steering cylinder. The large cylinder—no issue, but the control
valve appears to be slightly different in design than the shop
manual shows. There is no snap ring in the linkage end and
there is a different oil seal as well. Did they redesign the
control valve before 1972? Any information would be
appreciated. Plus, what is the best way to pull the friction fit
“screws” for the valve cap?
steering cylinder. The large cylinder—no issue, but the control
valve appears to be slightly different in design than the shop
manual shows. There is no snap ring in the linkage end and
there is a different oil seal as well. Did they redesign the
control valve before 1972? Any information would be
appreciated. Plus, what is the best way to pull the friction fit
“screws” for the valve cap?