Hello, I m looking for information on where I can tie into the high pressure hydraulics on a Massey 1100. I believe there is a port somewhere on the rear of the tractor near the three point and remote valves that I could tie in and add a closed center valve to operate a loader and free up my remotes. I m just not certain which port or where it is. Thanks in advance for any advice.
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.