I have started to remove the 3.152 3 cylinder gas engine from my 1974 mf 135. From what I can see everything is disconnected and ready to come a part. I'm having trouble getting the engine to come a part from the transmission. Is there something that I could be missing? It looks like I have all the bolts out around the outside and all the linkage loose. Could it just be tight? I'd appreciate any help. Thanks in advance.
- Thread starter kermkep
- Start date
miner09
Well-known Member
- Location
- Pattonville Texas
Look close I've missed a lower bolts before.Also there may be a bolt(nut)
on very top housing under where battery sets. Opposite side where other
bolts are.
on very top housing under where battery sets. Opposite side where other
bolts are.
Hey minor09, You were right. I finally found the bolt that held the starter on went through the starter, then the engine block. and threaded into the bell housing. As soon as I took the starter off
the engine and transmission came apart just as I expected them to do. Thanks for your input. I appreciate being able to get advice from someone that has had the same problem before. Thanks again.
the engine and transmission came apart just as I expected them to do. Thanks for your input. I appreciate being able to get advice from someone that has had the same problem before. Thanks again.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy