Engine Overhaul

Skip Burney · Jan 19, 2019

Got the crank back, new pistons and liners done and going back togther.

John Deere D · Jan 19, 2019

Beautiful......

Chrome plated or cast liners?

Bob...

Skip Burney · Jan 19, 2019

Cast liners I shrunk them with dry ice and isopropnol and they went in just fine

David G · Jan 19, 2019

I would put a bolt and washer on the top to prevent any liner movement until the head is on.

Skip Burney · Jan 19, 2019

Thanks I will do that they actually pressed in pretty snug, I soaked them in dry ice and alcohol for about an hour and I had turned an aluminum plug that would pilot down into the liner and shoulder over the top lip of the liner about a half inch all the way round and had the block in the press and they pushed right in. I checked them with a straight edge and they are flush.

ASEguy · Jan 20, 2019

It looks really good. Nice job.

Engine Overhaul

Skip Burney

Member

John Deere D

Well-known Member

Skip Burney

Member

David G

Well-known Member

Skip Burney

Member

ASEguy

Well-known Member

Similar threads