Finally got my 245 lift shaft out by soaking, beating and finally pressing it out and have new bushings ordered. Got the pump to come out by loosening all the tranny to hydraulic housing and after degreasing it found one of the 4 valves snap rings looks kicked out of its groove. I would like to know the cheapest way to fix without having to go back and redo. This is my first tractor with lift problems requiring a pump pull.
- Thread starter 2tractors
- Start date
Brendon Warren
Well-known Member
I just bought a brand new pump on eBay for $195. Rebuild kit was $100, relief valve was $25, new filter was $15. So for the $60 more dollars I went with the whole new pump. This was in a 65 Massey.
Phil Tibbetts
Well-known Member
Brendon is right, just buy a new pump and you will be all set for another 50 years.
ptfarmer
Well-known Member
- Location
- San Antonio, Tx
The main thing is to get the one with correct amount of drive splines on the pump shaft. The old MF pumps have a 10 spline pump shaft, the newer 245 should have the 21 spline pump shaft.
Brendon Warren
Well-known Member
They're showing two pumps on this site for like $550. Yikes. I did see a couple on eBay for around $300. These were 21 spline but the relief valve appeared to be in a different location. I think they were referred to as MKII.
Brendon Warren
Well-known Member
They were brand new pumps.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy