|
| |
| John Deere Tractors Discussion Forum |
Loader for a 520
| Author |
[Modern View] |
|
drastic dave
02-22-2021 16:06:16
|
Any suggestions as to a front loader for a 520 John Deere. Want a hydraulic bucket.
|
|
|
|
Tx Jim
02-23-2021 14:57:10
|
|
Re: Loader for a 520 in reply to drastic dave, 02-22-2021 16:06:16
|
|
| |
NY 986
Correction: after posting photo I see a portion of the crosstube & I think cylinder is in center of bucket. :oops:
Sorry for confusion, Jim
|
|
|
|
Tx Jim
02-23-2021 14:52:43
|
|
Re: Loader for a 520 in reply to drastic dave, 02-22-2021 16:06:16
|
|
| |
Quoting Removed, click Modern View to see
I was thinking model 48 loader had only 1 bucket operating cylinder that was mounted in center of bucket & crosstube on boom. Cylinder bucket on loader on 630 is on the side of bucket with no crosstube visible.
|
|
|
|
John Deere D
02-23-2021 12:52:57
|
|
Re: Loader for a 520 in reply to drastic dave, 02-22-2021 16:06:16
|
|
|
NY 986
02-23-2021 05:39:16
|
|
Re: Loader for a 520 in reply to drastic dave, 02-22-2021 16:06:16
|
|
| |
If equipped with a narrow front end then a JD 45 would work. They were offered with hydraulic bucket as well as manual trip bucket or could be adapted to hydraulic. Then there is the far less common 45W loader for those tractors equipped with WFE. If you are willing to do fabricating then a lot of loaders can be made to fit. There is a JD 630 on Tractor House that has a 148 loader on it.
|
|
|
|
NY 986
02-23-2021 06:43:40
|
|
Re: Loader for a 520 in reply to NY 986, 02-23-2021 05:39:16
|
|
| |
That 630 has a 48 not a 148 loader. That does not change the point that there have been 148 loaders adapted to the 2 cylinder tractors. I've seen one in person mounted on a 730 tractor. Probably could google pictures.
|
|
|
|
tomstractorsandtoys
02-22-2021 18:41:59
|
|
Re: Loader for a 520 in reply to drastic dave, 02-22-2021 16:06:16
|
|
| |
If you can find one model 48 with the universal mounting frames for 2 cylinders. Dad had a new one on a 720 and I sold one about 5 years ago. Tom
|
|
|
|
coonie minnie
02-25-2021 10:37:31
|
|
Re: Loader for a 520 in reply to tomstractorsandtoys, 02-22-2021 18:41:59
|
|
| |
Tom, did those loaders have bigger cylinders? I'm guessing the lower pressure of a 2 cylinder hydraulic system combined with small diameter cylinders reduced the lift capacity quite a bit...
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1967 Ford 3000
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
