(800) 853-2651
SHOP NOW

John Deer 730

K

Karl Kostman

Member
Hello Folks I noticed the Stiener has a sale going on and I need to rebuild my clutch on my 50 730 diesel I know I need the clutch plates etc. but my question is concerning the dogs at the bottom of the clutch I think that the name for those pieces while I am ordering the clutch rebuild kit would I be smart to order and replace these pieces at the same time? I dont know if this clutch has ever been rebuilt before and based on how worn out the plates are I doubt it has. Let me know your thoughts on the clutch dogs and I can get my stuff ordered tomorrow!
Thanks much!
Karl
 
I don't think you can over do a clutch on one of those. If you had it apart it would help, but if you're on a deadline to order, I'd get the toggles, dogbone's, pins, drive pin and maybe the bronze bushing. The bearing can be gotten 'anywhere" if necessary. You've got a fine machine there; best of luck with it.
 
They might be ok but for sure change the bolts out. They stretch over time. We usually order all the clutch parts from Martin Tractor Parts and have had good luck with them.
 
Thanks very much for your input guys its very much appreciated!! I will check out Martin Tractor parts and if their prices are equal to Stiener I will order from them!
Thanks again
Karl
 
You must log in or register to reply here.

Similar threads

G
1970 4020 PTO
Replies
3
Views
446
Tx Jim
Tx Jim
olgentdc
Starter 800-730 diesel interchange ?
Replies
6
Views
404
chuck machinist
chuck machinist
P
Can I put 730 LP pistons in a 630 engine?
Replies
4
Views
335
used red MN
U
I
John Deere 2020 PTO questions
Replies
3
Views
291
Jim.ME
J
D
JD 730 Gas Engine Rebuild
Replies
2
Views
227
Darbt
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top