JD6030 Clutch Tool

Hay maker2 · Dec 9, 2019

Looking for the JDE-32 tool used to set the pressure plate fingers. Does anyone have the dimensions?

Thanks

JIM MN · Dec 10, 2019

I have OTC JDE-32 tool in front of me.. Dimensions are; it is a rectangle piece of metal--3/16" thick.
It is 5" long by 1 1/4" wide. It has a notch out that is the finger height.. It is 1 1/4" out of the 5"
long side and 23/32 deep out of the 1 1/4" width side. The 25/32" is your finger height.... hope you
understand. 9524665722

Hay maker2 · Dec 10, 2019

(quoted from post at 17:32:00 12/10/19) I have OTC JDE-32 tool in front of me.. Dimensions are; it is a rectangle piece of metal--3/16" thick.
It is 5" long by 1 1/4" wide. It has a notch out that is the finger height.. It is 1 1/4" out of the 5"
long side and 23/32 deep out of the 1 1/4" width side. The 25/32" is your finger height.... hope you
understand. 9524665722

Like this?
If yes, I will cut it out with a laser or waterjet tomorrow

JIM MN · Dec 10, 2019

Yes, that is it.. One change---notch; the finger height is .810 not 25/32. when adjusting finger set at...
+ - .oo5. The rest is good-to-go... jim

Hay maker2 · Dec 10, 2019

(quoted from post at 18:54:04 12/10/19) Yes, that is it.. One change---notch; the finger height is .810 not 25/32. when adjusting finger set at...
+ - .oo5. The rest is good-to-go... jim

Something like this:

JIM MN · Dec 10, 2019

That is correct. Glad to help..

fdt860 · Dec 10, 2019

I borrowed one from a deere meczni that had been cut in a piece of hard plastic. Was good enough.

4520BW · Dec 11, 2019

To align the discs you can use a 1000 rpm pto shaft.

JD6030 Clutch Tool

Hay maker2

Member

JIM MN

Member

Hay maker2

Member

JIM MN

Member

Hay maker2

Member

JIM MN

Member

fdt860

Well-known Member

4520BW

Well-known Member

Similar threads