(800) 853-2651
SHOP NOW

Aftermarket 3020 Tach?

B

Bob in SD

Member
Most seem to be in the $170-$200 range, but I see a couple such as
<a href="https://www.walmart.com/ip/Tachometer-For-John-Deere-2510-2520-3020/194943158">here</a> are about half of that. All of the cheaper ones have a blurrier picture than the ones from Steiner, etc. Has anybody tried these? Are they all made in the same place, or are there even cheaper knock-offs of the knock-offs?

All I _really_ need is an hour meter, is my non-functioning fuel gauge a 2" diameter? I looks smaller from outside the dash.

Thanks in advance,

Bob
 
I've bought the expensive genuine jd tach and haven't been impressed. The quality on all of them seems to be junk. I haven't tried rebuilding an old one yet but that is what I'm going to try next.
 
Yes there are cheap grade and even cheaper grade junk just like anything else . Contrary to popular belief not all parts are the same
 
Even Deere's are not as good as original.
Follow other's advice and get yours repaired.
 
You would be surprised how many people call looking for low houred tachs.I don't care for the 3 digit Mexican tachs from JD Most of the time Steiner or A&I have the best replacement As stated Star Speedometer 386-569-5284 in Palm Coast Florida ad appears in Green Magazine monthly
 
I actually called Star and the cost to rebuild an original tach is $265 and it is guaranteed.He said there are 3 options hours what they read or you can have them set at 0 or he can add hours but never subtract.10 day turn around.He stated all the new are made of plastic and are junk.
 
Check with Jerry Trcka @ evergreen restoration. I think he rebuilds them I know he'll set it to the hours you request. Sorry you'll have to Google the number I don't have it handy.
 
Evergreen # is 715-635-8629 or cell 715-520-7876.He just advertises to do gauges you will have to call to find out.I bought a tractor that had redone gauges from him and they were excellent and tach was also redone but don't know for sure where but hours were supposedly the correct hours.
 
You must log in or register to reply here.

Similar threads

B
Aftermarket 3020 Tach?
Replies
0
Views
141
Bob in SD
B
B
Massey 50 - Need new tach and alternator / generator
Replies
5
Views
996
Bret4207
B
H
Tachometer
Replies
11
Views
398
olddog
O
R
67 3020 gas issues. Carb related?
Replies
7
Views
836
buckeye al
B
M
Kohler K series, 2cyl, repair or engine swap?
Replies
10
Views
1K
MarsEnthusiast
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top