(800) 853-2651
SHOP NOW

DLTX 46 Adjustments

Here is the procedure
a278771.jpg
 
In addition to the procedure below ( actually , set idle at 2 turns initially )...once you have initially set needles and thrown throttle open to wide open...slowly close load needle all way. Tractor rpm should not change . If it does or stops, your carb needs re-built and/or your intake manifold is cracked and/or leaking air. If , in fact it stays running fine at fast idle, now start to slowly close the idle needle little at a time until tractor stops. From there open it back up 1/4 turn and leave it alone. It's set. Now open load back up 1 turn and re start tractor. Throw open throttle quickly and if it accelerated without spitting and popping cleanly up to wot then load is set and will be fine for anything less that pulling a plow etc in which you may want to go richer or leaner 1 - 2 clicks if needed. You always set idle with load closed and at wide open throttle. (load must be open to get it to wide open tho)
 

Thanks guys. I'll see if I can run through this in the next couple of days. I may also need to have the ports drilled out. Can you email me separately your info(price/timing/shipping address) in case I want to send you my carb? Thanks.
 
Thanks Randy. I'll send you the carb. I have a local tractor show on Sep 28-30..any chance you can have it back to me by then?
 
You must log in or register to reply here.

Similar threads

J
Right carb for my 1944 A
Replies
11
Views
591
coonie minnie
C
S
Carb rebuild
Replies
6
Views
417
Stuart Hooley
S
D
DLTX 71 carb rebuild
Replies
3
Views
228
sandhillcarbs
S
620 John
'37 A carb questions
Replies
3
Views
284
620 John
620 John
acorn
1955 JD Model 60 Carb - What Model?
Replies
7
Views
226
Pete in MD
Pete in MD
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top