riveroadrat
Well-known Member
Im looking for a 346 baler front half driveshaft where you hook it to the tractor. Can I just make one out of square shaft and a yoke?
- Thread starter riveroadrat
- Start date
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
I suppose you could make one out of square shaft BUT make sure you phase(time) u-joints correctly
susandiane
Member
Tractor Supply, Orschleans and Pioneer sell the shafts around here, assuming they are the same size as yours. I had to buy both parts to get my post hole digger operating. Good luck!
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy