510 baler

sfcsanderson · Aug 30, 2011

Just bought a 510 round baler. Anyone familiar with this baler? I know I can hook up one set of hoses to my remote but what do I do with the other set? One set for knotter, one for ejection lift. I have a loader with a two lever spool. If I use the loader quick connects which lever will be the control and can I leave the lodaer on?

Thx, Shane

Sam Vastano · Aug 30, 2011

Best way is to just try it. I even get them mixed up on ours sometimes.

sfcsanderson · Aug 30, 2011

It should work with my valve spool for my loader, shouldn't it? Thanks for the reply.

travz500 · Aug 30, 2011

it should work fine just remember to hook them up the same way every time then you wont forget what lever does what one set is to tie the bale and the other is to dump the bale good luck i hated our old 510 we still got it for a back up but will probably never use it but my mohter in law still owns it and so we bought a 535 w/net wrap and will never look back to the 510 again

Tx Jim · Aug 31, 2011

(quoted from post at 21:01:41 08/30/11) It should work with my valve spool for my loader, shouldn't it? Thanks for the reply.

I would hook one set of the hoses to the loader bucket circuit. That way one could still raise/lower boom if required.

sfcsanderson · Sep 1, 2011

Thanks all. I got it figuured out. Have to add Pioneer quick couplers to my loader spool. Actually pretty simple. Thanks again.

510 baler

sfcsanderson

Member

Sam Vastano

Member

sfcsanderson

Member

travz500

Member

Tx Jim

Well-known Member

sfcsanderson

Member

Similar threads