Kevin Happke.... baler gauge....

Absent Minded Farmer · Mar 4, 2021

My apologies, things have been hectic around here & I didn't see that you responded to my question about the baler gauge until someone just added to the post today. The gauge is meant to keep everything pertaining to the knotters in spec. Searched all the manuals I have & can't seem to find a part number. Could also be that I'm looking too hard & breezing right by it.

I'll leave a link to my video about it below. That should explain it better.

Mike
McCormick IH Knotter Check Up Gauge....

DeltaSteve · Mar 4, 2021

Neat video. Wonder if I could get a gage like that. I still have (working) 55 wire baler.Know of a couple of 'stringers' in the area.

Absent Minded Farmer · Mar 5, 2021

I can't seem to find any info that it could be used on a wire twister. Not sure if there are different instructions for it or a different gauge all together.

Mike

DeltaRed · Mar 5, 2021

Late in the video they mentioned a similar tool for a wire baler was available.

SVcummins · Mar 6, 2021

The same gauge has all the the steps to check a wire baler too he said . Thats why it has two ends l

SVcummins · Mar 6, 2021

Absent Minded Farmer · Mar 8, 2021

Oh yeah. Duh! I didn't hear it because I was looking for it.

Mike

Kevin Happke.... baler gauge....

Absent Minded Farmer

Well-known Member

DeltaSteve

Member

Absent Minded Farmer

Well-known Member

DeltaRed

Well-known Member

SVcummins

Well-known Member

SVcummins

Well-known Member

Absent Minded Farmer

Well-known Member

Similar threads