I was having problems with the safety trip popping loose and mower swinging back. It was due to the mower bar not being adjusted level but rather being adjusted with bar tilted to far down
Book says to adjust the trip mechanism so that when 400 pds pull is on end of mower bar it will trip. So how have you set this adjustment to 400 Pounds of trip force?
Do not have a scale that big. Thought about tiring rope to end of bar and run it to a pulley and then to a big bucket and put 400 pds I’d steel in the bucket. Over tighten the spring first then back off till it trips.
Thoughts.
Book says to adjust the trip mechanism so that when 400 pds pull is on end of mower bar it will trip. So how have you set this adjustment to 400 Pounds of trip force?
Do not have a scale that big. Thought about tiring rope to end of bar and run it to a pulley and then to a big bucket and put 400 pds I’d steel in the bucket. Over tighten the spring first then back off till it trips.
Thoughts.