Thanks for all the great information. I have wanted to try to restore the Love disc, because it's in good working condition other than for the seized bearings and rounded shafts in places. I have not been able to get the wood bearings removed from the housings though. I looked in to replacing the housings and the bearings but have not gotten very far on that project. It has 20 inch discs, 5 per gang. My New Holland tractor is 30 HP, 4 WD.
Re: 8 foot John Deer Disc question in reply to Cedar22, 05-29-2020 06:52:31
Here are a few photos of the Love disc. I had removed one of the gangs to see if I could get the bearing out of the housing, but I was not able to. I am not sure why there is a round metal pipe inside the bearing, when the shaft is square.
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.