Please help with model..kewanee disc

Greetings!
Sorry to be short as this is my 1st post. I am trying to ID a disc. I know it's a kewanee but cannot seem to figure out the model.

I am in urgent need of a wheel bearing. The wheel is off at the moment and the wheel bearing I bought from shoup on a guess SH98179 was incorrect. Guessed that one because it's a 5 bolt.

Any help is appreciated. Thanks in advance.
 
mvphoto36946.jpg


mvphoto36947.jpg


mvphoto36948.jpg


mvphoto36949.jpg
 
It's not a Kewanee. I'm looking through the Kewanee parts book and all it shows is 4 & 6 bolt wheels and the early spoke wheels. I could furnish Timken numbers for any of those.
 
(quoted from post at 18:35:26 05/30/19) Take the bearing and race to a parts house and let them match the numbers to a new one. Napa would be a good start.

Thanks! I didnt have the bearing. It was metal rim to metal rod when we noticed so everything was blown out. I didnt want to take the other one off because I was afraid it would need replaced as well. I'm just trying to get the thing at least moveable. I may have to do that though and just replace it too because I'm sure it needs it
 

Really?
It's my neighbors and we were borrowing it. We told him that the bearing blew out so asked for the make and model. he was confident on the make but had no idea about the model.

We went with the guess for the part because Shoups have that it fits specific series but then mentioned kewanee 5 bolt. It was the only one that showed 5 bolt so process of elimination told us to order that one... but its def not the right part.

Now the neighbor is in his late 60s and knows his farm equipment so I didnt doubt him...but perhaps hes confused. He had this new or near new on his family farm because we also asked if the hub would still be orig.
 
if you are going to fix tractors or implements you need a caliper. Wheel bearings come in discrete sizes and a caliper will tell you the important details like the inside diameter, outside diameter, and width. With that you can buy the bearing that fits, not just guess.
Digital Caliper
 

Taking the other side off and measuring with a caliper is only a 5 minute job. You can add five to that by doing the right thing and adding a little grease to it while you have it open. Heck, you don't even need to jack it up!!!
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top