(800) 853-2651
SHOP NOW

JD 467 baler

W

WAYNE-N-TEXAS

Member
Going to be a fun hay season. Mowing with my JD 5303 and clutch goes out. So I take the baler loose from the MF 4253. Fluffed yesterday, then rake this morning came back to the house reinstalled baler .boy that PTO shaft is a bugger for some one over seventy. Now, the Baler's (JD 467) monitor has E1 02 along with the warning buzzer going off. showing all time, disconnect cable from baler and the monitor shows the same thing E1 02 and sound. So must be tractor side. Where should start, it was working when I quit last season. Did nothing on baler that should have caused this, just the normal things like greasing and belt work.
 
E1 02 is code for bale size sensor disconnected or shorted to ground. Mine sometimes throws that code when it is first plugged in because one of the pins in the connector has got pushed back instead of going into the female end.
 
After all day, you're right, bent pin. I had a stroke last year, my eye sight is not good in my shop. A friend come by and seen it. Thanks
 
You must log in or register to reply here.

Similar threads

M
JD 467 baler monitor question
Replies
3
Views
272
Mshudgins
M
tomstractorsandtoys
Deere 467 baler
Replies
6
Views
643
Tx Jim
Tx Jim
B
John Deere 467 baler
Replies
6
Views
328
bernieinva
B
tomstractorsandtoys
Tx Jim Deere 467 baler question
Replies
11
Views
779
rockcreek4630
R
S
JD 510 Round Baler Belt length???
Replies
3
Views
769
Tx Jim
Tx Jim
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top