riveroadrat
Well-known Member
When you open the gate the very bottom roller has a collar with a pin or set screw on the outside. Is it a roll pin or rounded out set screw? I dont think its been off before. I didnt see it in the parts catalog.
- Thread starter riveroadrat
- Start date
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
The spring pin(key 19) for the collar is part number 34H336(5/16" X 2-1/4")
riveroadrat
Well-known Member
We got them out by dropping the tailgate edge on a big block of wood on the ground to take the bounce out of the hammer blows.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy