MaverickM23
Member
I am rebuilding the auger for my 615 combine, couldn't find a used one so I made my own. The auger that exits the grain tank had been
welded when I bought it and it never seemed right so I'm fixing that too. The problem is I don't know what it should look like at the end
of it. I have tried finding pictures but the one I have attached is the best I can find. Trying to see if anyone could get me a close up
picture of the end of the auger so I can see how far the flighting extends past the shaft and where I should weld on the drive pin. Thanks
in advance.
welded when I bought it and it never seemed right so I'm fixing that too. The problem is I don't know what it should look like at the end
of it. I have tried finding pictures but the one I have attached is the best I can find. Trying to see if anyone could get me a close up
picture of the end of the auger so I can see how far the flighting extends past the shaft and where I should weld on the drive pin. Thanks
in advance.