Pine creek
New User
I have a M2 Gleaner and its stuck in 2 gear. The header subsequently also does not raise/lower. The high low range does shift into nuetral ho and lo. Any one have advise? Is this electronic? Fuses all good.
- Thread starter Pine creek
- Start date
I don't know if there's a similarity or not, but my K2 hung up in gear. I had to get down on the right side of it with a tire iron
and pry on the linkage to pop it out. It did it again when I was cutting oats this year. I kept going for a little while and it
worked itself out. How it's tied in to the header lift, I don't know.
and pry on the linkage to pop it out. It did it again when I was cutting oats this year. I kept going for a little while and it
worked itself out. How it's tied in to the header lift, I don't know.
Pine creek
New User
Thank you. I will try more pressure. I did pound on linkage but was a little worried about breaking it
Pine creek
New User
It worked with a crow bar. The header was a fuse. Both mutually exclusive. Crazy. Thank you!
?? I hope your issue is a simple fix Pine creek
New User
It is a variable speed gear shift standard transmission. Eats beans pretty good! U have a safe harvest as well.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy