(800) 853-2651
SHOP NOW

1968 Economy / Power King Tractors

K

Kiltedman

New User
I need help.
I was replacing my regulator and coil.
Had to go out of town. Son in law came over and "fixed" it for me. Now it will not start.
Is there a manual on the electrical(ignition system available? Or has anyone experienced this problem and knows the wiring from the coil and points to the regulator? I would have taken pictures of the wiring had I known I would be receiving help.
I really need some pictures to show me where all the wires go from the regulator.
Any help?
 
Here's a Kohler wiring diagram for the rectifier
regulator if that's what you have. The outer terminals are for the AC wires from the stator and the other is DC volts. You need to use a volt meter and see if you're getting voltage to your coil. If it has points they need to be open and you should have voltage on both terminals with the ignition switch in the on position. Since your battery is Negative grounded the wire from the neg terminal on your coil should to the points or ignition module.
If it has points clean them. Hal
5tungm.jpg
 
17hp kohler??? That shouldn't be. Are you sure about that or was it a simple typo? Can't be too careful.

If it's the old type, automotive type coil, make sure you get one with an internal resistor.
 
You must log in or register to reply here.

Similar threads

G
MF35 Diesel Deluxe ignition switch help
Replies
6
Views
464
Greystone
G
M
Ford 5000
Replies
2
Views
174
Janicholson
Janicholson
crsutton81
Super A 12v conversion
Replies
11
Views
831
Graysonsutton
Graysonsutton
M
UTS 12 volt conversion
Replies
9
Views
521
J.Wondergem
J.Wondergem
P
9n rebuild problems
2 3
Replies
51
Views
2K
Hobo,NC
Hobo,NC
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top