(800) 853-2651
SHOP NOW

HELP! NEED a Deutz Engine # K341S 71343

B

Barnmgb

New User
Hi any one have a K341S 71343 Deutz-Allis Kohler engine that runs good for sale? Or someone I can contact to purchase? To go into a Deutz 916 would also fit some simplicity models as well...Would like to keep original if possible rather than repower with different engine. Thanks in advance!! Matt

mvphoto25313.jpg
 
Normally I would but, it threw a rod and broke the camshaft and crankshaft journal also got scored as well as the cylinder wall which will now have to be bored out.
 
You haven't priced Kohler parts in a LONG LONG LONG TIME! I rebuilt a Cub Cadet spec K241 about 5 years ago, Everything was $100 or more. Stellite exhaust valve, seal/gasket kit, conn rod, all $100, piston and rings over $200. I used a lot of Stens parts in that rebuild.

I doubt you can rebuild with the cheapest imported parts and a little machine work for $200. I had cylinder bored & honed +.010", valves ground, head planed, crankshaft ground -.010", and bill was $130.
 
Yes, I know that Kohler parts are ridiculously overpriced.
You can spend several hundred dollars on parts, plus several hundred dollars in machine work if you want.
Most of us aren't that proud.
Parts from Stens at an automotive parts store, or online kits are the way to go.
 
Good cranks and cams are readily available.
New rings and nothing else might get you by in the short term, but
the cylinder should usually be bored for a good overhaul.
If the scoring is bad, a repair sleeve works.
 
You must log in or register to reply here.

Similar threads

F
Help with 1841 starter
Replies
12
Views
1K
Eman85
E
D
1999 International 4700 with a DT466E engine
Replies
15
Views
2K
SkipperII
S
M
Kohler K series, 2cyl, repair or engine swap?
Replies
10
Views
1K
MarsEnthusiast
M
R
Need help with Ford 2000 2cyl gas with Holley Carb rebui
Replies
7
Views
1K
ROBOB1
R
T
Erickson Farmalll forklift engine dating help
Replies
9
Views
562
TRSJEEP
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top