(800) 853-2651
SHOP NOW

Fordson Dexta Diesel

A

aklimek100

New User
This message is a reply to an archived post by ROADMAN on May 18, 2011 at 06:08:25.
The original subject was "Re: Fordson Dexta Diesel".

in 2011 you had a super dexta i'm looking for a block and crankshaft if you still have it or know where it is
thanks
my ph # 315 404 6324
thanks

Tony
 
(quoted from post at 08:40:36 02/27/19) I have a complete Dexta engine for rebuild
Click to expand...
CTOR PUMP

IS IT A 144 OR 152 ? IF YOU HAVE THE INJECTOR PUMP. YOU CAN TELL THE CU. IN BY IT SHOULD HAVE SIMMS PUMP IF THE SER# IS P4588 ITS 144 IF ITS P4696 IT A 152.HOW MUCH DO YOU WANT FOR THE MOTOR?? I'M IN FLORIDA BUT WILL BE GOING THRU VIRGINIA THE FIRST WEEK OF APRIL.
ADVISE OR CALL 315 404-6324
THANKS
TONY
 
It is the super with mechanical pump.
Engine is not frozen. $500, with.
Flywheel, Clutch and bolt on items.
I used the complete rear end of the tractor
when I had to replace a transmission on one
of my Dexta tractors.
WAYNE
 
(quoted from post at 19:40:51 03/17/19) It is the super with mechanical pump.
Engine is not frozen. $500, with.
Flywheel, Clutch and bolt on items.
I used the complete rear end of the tractor
when I had to replace a transmission on one
of my Dexta tractors.
WAYNE
Click to expand...
.
Wayne
is it a super dexta or just a super. i don't think a super will work for my application. it is a three cly perkins diesel correct. any way to post a picture? you are located in Virginia? please advise as soon as possible as i'm headinh north soon.
 
My farm is 1.5 hours drive one way. Not going there until this weekend.
It is a super, 152 3 cylinder Perkins type engine. It has the Minnmec pump. The tractor has super nose cone and tin.
Like I said, I used the rear end, because after 1961.5, all the tranny's use a larger output shaft and bigger connecting shaft. I married engine tranny back together without a connecting shaft between tranny and rear end (old early Dexta rear end)
I will have to pull the engine. This is a parts tractor.

Wayne
8047040091
 
You must log in or register to reply here.

Similar threads

7
Looking for an Elenco 4wd front end - Tony Jacobs contac
Replies
1
Views
296
michford
michford
RBnSC
Test
Replies
3
Views
216
47fivewindow
47fivewindow
L
Early Fordson tractors
Replies
2
Views
758
Leroy
L
B
In the fullness of time
Replies
1
Views
235
Steve in VA
Steve in VA
C
Italian tractor parts
Replies
2
Views
1K
Pete in MD
Pete in MD
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top