NAA Jubilee PTO
[Return to Forum]
[Log in to Reply]
I have a jubilee that doesn't want to go into gear on the pto shift. I have used this tractor for bushoging for somewhere around 20 years now. I have built the trans with all new bearings around 4 years ago. It started not wanting to go back into gear when the pto was shiften in neutral a while back. I split the tractor and put new bearings in the transmission pto shifter housing (bolts to rear of trans and holds the countershaft bearing), replaced the bushing in the rear end housing and replaced the bearing in the rear bracket where the pto exits. IT still shifted in hard with the bushog on. Today I shifted it out and it would not go back in. I pulled the side plate off (with the shifter lever) and could not budge the shift detent rod, then split the tractor and still could not find anything wrong. Pulled the detent ball, put the shifter back on and it seemed to work fine. I could not find any noticable play in the countershaft. Whats wrong!
Today's Featured Article -
It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Fiat 800E/ AgriPower 8000 Tractor for parts. Engine burned, but didnt get the injection pump or hydraulic pump. Back end of the tractor still ok, sheet metal is still there. Good for parts.
| Copyright © 1997-2021 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy