(800) 853-2651
SHOP NOW

841 PM rewiring help

R

RedheadRanch

New User
Hi,
I have an 841 that I am trying to rewire. It was such a mess with tangled, broken missing wires I can't seem to get it right. So

I have a 12 v coil 3 wire alternator and a starter selinoid. I think I about have it but I removed the voltage regulator and now I'm not sure how to hook the wires up. I can switch to a single wire alternator but I still don't know what this box thing is. I want to remove the voltage regulator.

There is a frame there is it that simple to just attach the wires? Or is there some sort of junction box?

I know this isn't clear. Sorry. Maybe pictures will help.
I can't figure it out.

cvphoto122529.jpg
 
It should be located about half way down the steering column. There is a flange spot welded on where it would screw on. Just about any junction block will do, if you can adapt the mounting holes. We made the junction blocks for all of our hundred series tractors out of fiberglass and stainless 10-32 studs.
 
You should have another problem with that diagram, as the solenoid on X01 tractors should have 4 terminals.
uWgHXAb.jpg
 
You must log in or register to reply here.

Similar threads

J
Ford NAA 3 wire alternator to 1 wire harness
Replies
14
Views
559
JMOR
J
S
Ford 724 Loader on Ford 841 tractor
Replies
4
Views
382
Shelbygt
S
N
1969 Ford 4500 alternator wiring
Replies
6
Views
698
Nerolord
N
waugh621
Voltage regulator?
Replies
13
Views
376
wore out
wore out
S
Yanmar Alternator Not Charging
Replies
5
Views
281
hearnc843
H
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top