Does anyone know if the the fenders and running boards from the 5000 thru 7600 models made in the 1970s work on the 5610s thru 7810s models made in the 1990s? Got a 7810s and I don't like the way the fenders and running boards touch. It makes it hard to get off/on. The foot throttle and hydraulic filter are the problems that I've noticed as possible on the right side. It looks like it might work, but don't know if the mounting holes for the running boards are the same from the 1970s to 1990s.
- Thread starter jsp5755
- Start date
Bern
Well-known Member
- Location
- Mount Vernon, WA
I'm 90+ percent sure they would interchange.
Destroked 450
Well-known Member
- Location
- Harned, Ky
The running board mounting holes are the same so yes they can be interchanged
The running boards on the S models will be wider than the earlier models, so installing the narrow boards could cause a issue with the foot throttle
If the S model running boards are similar to the ones I removed from a 95 3930 their brackets will support the board without it being attached to the fender, you could simply swap out the fenders and keep the wider running boards
The early Euro Fords with fender attached running boards would bend down if no attached to the fenders
There's been a number of times I've wished I had the S model fenders when feeding livestock in muddy weather, no fun when a rear tire squirts manure filled mud and water up between the fender and running board, it will soak the back of our pants leg and any part of you back side that isn't protected by the seat
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy