I have a 3400 Ford that someone has removed all of the original steering and converted it to an orbital valve hydraulic steering. The problem I am having is that the tie rod ends they used are not original. They are 7/8-18 male thread with a tapered pin size being .875 to .770 with a 5/8 fine thread to secure to steering knuckle. 3.9 in length from centerline of ball to end of 7/8-18 threads. Everything I have found so far has a tapered pin that is too small. I have exhausted the parts people at John Deere, New Holland, Napa, Car Quest, O'Reilly's and scoured the internet thus far with no luck. Please help!
- Thread starter Treadnmud
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy