158 motor in my 3400 had been sitting for quite some time and is rusted up pretty good from condensation. Have the front torn down completely and have the cam freed up. Lifters will move but still a little stiff in the bores. I figure they maybe corroded under the lifter bore also. Can I get enough access to push them out after I get the motor on the floor and get the crank out of it. I doubt the cam journals will clear till i get the lifters up a little. I still have 1 or maybe 2 really stuck pistons. Thanks again.
-greg
This post was edited by Mechetc on 07/22/2021 at 05:00 am.
-greg
This post was edited by Mechetc on 07/22/2021 at 05:00 am.