Ultradog MN
Well-known Member
- Location
- Twin Cities
I bought this old milling machine last fall and have been going through it. Had it completely apart - new bearings in the spindle, bunch of small repairs, adjustments, etc.
Most of the work was cleaning 68 years of grime and crud off and out of it.
I figured while it was apart I'd get some paint on it. Plenty of extra Blue and off White around here so I figured why not. Prime then 2 coats, all with a brush.
I just put the table back on today.
Still things to do and then start building a phase converter so I can run it.
A little different than a tractor but still fun to tinker with.
Most of the work was cleaning 68 years of grime and crud off and out of it.
I figured while it was apart I'd get some paint on it. Plenty of extra Blue and off White around here so I figured why not. Prime then 2 coats, all with a brush.
I just put the table back on today.
Still things to do and then start building a phase converter so I can run it.
A little different than a tractor but still fun to tinker with.