Adding a front loader to Ford 4610

Jim12

New User
Hello everyone, I bought a new Great Bend 332 front loader for my tractor. I am now looking for a
joystick and valve for it. Will the tractor serial# tell me the pump flow. The tractor data tells me 2 different
pump flows. It says 8.5 then it shows 14.1. Serial on the tractor is BB97053 Model DA314C. Hydraulic
Pump B02B. Hydraulic Lift 9B15. Any help will be greatly appreciated!
cvphoto70284.jpg


cvphoto70285.jpg
 
I'm not sure on those later models, but I'm pretty sure that the stock configuration for the 4610 had a single pump in the right side of the rear axle center housing like the earlier 4000 and 4600 models, but with either the xx10 or xx30 series you could add a second pump mounted on the left side of the engine back near the flywheel and the tractor would use the stock pump for the 3 point and could combine the flow of the two pumps for other uses. As I said, I'm not sure if that was introduced in the xx10 or xx30 series, but if it was on the xx10 series that could explain the two different numbers on tractordata.
 
The dual pumps were optional on those tractors, and there's no way to tell from the serial number plate which version it has. The only thing you can do is look at the rear LH side of the engine and spot either the pump or the 4-bolt cover plate.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top