I’ve got a 59 641D workmaster. Previous owner bent the
leveling rod so I searched for a new assembly and all are
shorter in length than the original. Got the NCA577A that’s
listed for it and the fork is same length but the threaded rod is
quite a bit shorter which hikes the right side up on a plow. Has
anyone ran into this and what box did you end up using?
Original is almost 28 in knuckle to knuckle fully extended
leveling rod so I searched for a new assembly and all are
shorter in length than the original. Got the NCA577A that’s
listed for it and the fork is same length but the threaded rod is
quite a bit shorter which hikes the right side up on a plow. Has
anyone ran into this and what box did you end up using?
Original is almost 28 in knuckle to knuckle fully extended