mikewood869
Well-known Member
Does anyone know how many splines are the input shaft for the clutch? Were going to be doing the synchros over on the tractor. I was also thinking of putting in a bigger clutch.
- Thread starter mikewood869
- Start date
Bern
Well-known Member
- Location
- Mount Vernon, WA
I *believe* it's 10, but don't hold me to that number - I'm going off memory. I can tell you for sure that if you currently have a 12" clutch
installed, that it can be converted to 13" by drilling the flywheel for the larger bolt pattern.
installed, that it can be converted to 13" by drilling the flywheel for the larger bolt pattern.
OP
OP
mikewood869
Well-known Member
Thank you, how many splines can there be? We haven't pulled apart the tractor yet.
Bern
Well-known Member
- Location
- Mount Vernon, WA
I'm pretty sure there's only one spline count during that era of tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy