I recently bought a 601 Ford corn picker. The person I bought it from had it on a 860, I'm putting it on my 860. I never saw his tractor so can't verify. The angle iron bracket that go under the axle don't seem correct. I cant hook the pto shaft up to the tractor. The husking unit seems several inches low. I've tried adjusting the center link, and the pto bearing support on my matches the picture in the owners manual. Can anyone give me measurement or pictures of the brackets?
Re: 601 corn picker mounts in reply to NWFORD, 11-04-2019 11:17:33
These are for a 601 or a jubilee I can't remember I had to make new ones for my 2810. If you need more measurements let me know. These pickers work great mine was a one owner it hadn't been used since the early 60's always shedded
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.