I recently bought a 2910 that was in overall pretty good
shape, but I did have a few small things that I wanted to
address just to make it the way I wanted it. I?ve got some
hydraulic leaks fixed and a few other odds and ends taken
care of. I got my new gauge cluster today that is the same as
they sell on this site, but it came with no instructions and
apparently there are no instructions sent with these no matter
where you order them. The terminals are laid out completely
differently and are not marked. Does anyone have experience
with where to put what wires from the old cluster to the new
one? Also in the second picture you can see how I found the
wiring for the fuel sending unit to the gauge. The whole cowl
area was packed full of leaves and debris, something had
been living a comfortable life in there. Anyways one of the
wires has been chewed through and looks like it has been
grounded out at one point, so I obviously will have to fix that.
However can someone shed some light on how those wires
are supposed to be? Thanks
shape, but I did have a few small things that I wanted to
address just to make it the way I wanted it. I?ve got some
hydraulic leaks fixed and a few other odds and ends taken
care of. I got my new gauge cluster today that is the same as
they sell on this site, but it came with no instructions and
apparently there are no instructions sent with these no matter
where you order them. The terminals are laid out completely
differently and are not marked. Does anyone have experience
with where to put what wires from the old cluster to the new
one? Also in the second picture you can see how I found the
wiring for the fuel sending unit to the gauge. The whole cowl
area was packed full of leaves and debris, something had
been living a comfortable life in there. Anyways one of the
wires has been chewed through and looks like it has been
grounded out at one point, so I obviously will have to fix that.
However can someone shed some light on how those wires
are supposed to be? Thanks