My advance is not working properly. The timing advances a little, as RPMs increase, but not very far.
The weights move freely.
I've attached some pictures of the weights.
In one picture I pushed the weights all the way out.
I then let the weights return as far as they would on their own (just the springs pushing them).
In the third picture I pushed them in against the shaft as far as they would go, which was quite a bit farther than the springs managed to accomplish.
Am I correct in assuming that the springs on my weights are not doing their job properly?
Brett
The weights move freely.
I've attached some pictures of the weights.
In one picture I pushed the weights all the way out.
I then let the weights return as far as they would on their own (just the springs pushing them).
In the third picture I pushed them in against the shaft as far as they would go, which was quite a bit farther than the springs managed to accomplish.
Am I correct in assuming that the springs on my weights are not doing their job properly?
Brett