Control linkage in FO-19 vs. FO-20

Good morning!

Can anyone tell me if the control linkage adjustment procedure in the FO-19 manual is the same as the one in FO-20?

I have a Jubilee that I've used the FO-19 for adjusting. And I have an 860 with original shop manual, but don't have the nuday tools. So before I spend money on a FO-20, just wanted to see if the procedure is exactly the same, including measurements, in the FO-19 and FO-20.

Thanks!

Jeff
 
'linkage"? I will assume that ;'linkage' in question is 3 point hydraulics & if so, then the answer is no, as the dimensions specified are different.
 
Thanks for the reply!

I should have been clearer about what I'm talking about. I have the top cover off and I'm replacing the o-ring/gasket on the hydraulic piston, fixing the cam follower pin, and re-adjusting everything else.

Looks like I'm just going to have to bite the bullet and pick up an FO-20.

Thanks again!
Jeff
 
(quoted from post at 10:49:32 07/12/19) Thanks for the reply!

I should have been clearer about what I'm talking about. I have the top cover off and I'm replacing the o-ring/gasket on the hydraulic piston, fixing the cam follower pin, and re-adjusting everything else.

Looks like I'm just going to have to bite the bullet and pick up an FO-20.

Thanks again!
Jeff
bout the only difference that I recall would be the deminsions of the "feeler" gauges.. Something like 3/16"D & 1/4"Posn on Jubilee and on hundred series, 0.395-0.397 for Draft and 0.448-0.450" for Position control.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top