mikewood869
Well-known Member
Are the wiring harness the same on a Ford 4400 and a Ford 3000? I have one for a Ford 3000 lying around. The 4400 has a alternator but I have a spare generator from the 4500 lying around.
- Thread starter mikewood869
- Start date
OP
OP
mikewood869
Well-known Member
At the moment, the old wiring consists of power going to the starter, cable going from the coil to the battery and touching off the solenoid. Since the solenoid sticks, just tap it with something. I thought they would have been the same since is the 3 cylinder 0000 series (same wiring harness, coil, solenoid, etc.). This is a gas engine by the way
Ultradog MN
Well-known Member
- Location
- Twin Cities
All the 3 cyl 2/3/4000 and derivatives
are the same electrically so yes, 3000
harness will fit.
are the same electrically so yes, 3000
harness will fit.
OP
OP
mikewood869
Well-known Member
Thank, you
Destroked 450
Well-known Member
- Location
- Harned, Ky
Not sure if gas and diesel have different harnesses or if gas has additional sub harness for the solenoid to coil connections.
Ultradog MN
Well-known Member
- Location
- Twin Cities
You use the diesel thermostart wire to
power the coil.
Just connect it to a different spade on
the switch.
The thermostart spade connector is a
big, honkin one. Replace it with a
"normal" size one that fits the spade on
the switch properly.
The start wire that goes to the solenoid
works on both gas/diesel.
Pretty easy.
power the coil.
Just connect it to a different spade on
the switch.
The thermostart spade connector is a
big, honkin one. Replace it with a
"normal" size one that fits the spade on
the switch properly.
The start wire that goes to the solenoid
works on both gas/diesel.
Pretty easy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy