(800) 853-2651
SHOP NOW

901 Steering Parts

C

Cutsit

Member
Was rebuilding my steering box since I had a bearing failure. I drove the steering shaft out and the sleeve came out in two pieces. It is aluminum, or at
least non-ferrous.

Can it be repaired by welding or some other method? If not, does anyone have a source for the part? I have tried eBay and all other internet sources.
I even tried to see if there were Ford car parts that would cross reference but have come up short.

Any help would be appreciated.
 
Here are some pictures. Ford part number is NCB 3734a.
cvphoto15147.jpg


cvphoto15148.jpg


cvphoto15149.jpg
 
I thought sure someone would have answered your first post or I would have pulled out the manual cutsit. There is a parts man on fleabay that goes by porter8n. If you look up some of his parts and click on his username you can message him about that part. A good welder can probalby fix that.
 
I sent him a message about that part. It is a part number #36 at CNH New Holland partstore. I don't know how to link it, maybe someone else will.



NCB3734A

SLEEVE

Steering Gear Lash Adjuster
 
Thank you for the response. I called my not-so-local New Holland dealer and that part is not available.

I will take it to the welding shop to see what they can do.
 
The part # I have on my parts sheet for the Ford 901 is 231190, ref # 15 is the picture.It is a retainer for the control valve ball stud.
Bob
 
(quoted from post at 15:56:20 03/31/19) The part # I have on my parts sheet for the Ford 901 is 231190, ref # 15 is the picture.It is a retainer for the control valve ball stud.
Bob
Click to expand...

What parts sheet are you looking at? We're all looking at #36 on the New Holland website. Part #NCB3734A
 
(quoted from post at 15:56:20 03/31/19) The part # I have on my parts sheet for the Ford 901 is 231190, ref # 15 is the picture.It is a retainer for the control valve ball stud.
Bob
Click to expand...

AHA! From your other thread, you're looking at the end of the assist cylinder. OP and the rest of us are looking at the steering gear!
 
You must log in or register to reply here.

Similar threads

B
Tafe 35di hydraulic steering cylinder seals
Replies
5
Views
905
Captainmal
C
A
steering motor
Replies
1
Views
264
stevieb49829
stevieb49829
C
MF Power Steering
Replies
1
Views
508
Mduncan60
M
A
Late steering box rebuild
Replies
1
Views
410
AM156
A
M
Ford 2000 Power Steering Pump Replace
Replies
7
Views
2K
Bern
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top