Good Afternoon, I?ve been working on a 5600 tractor?s power
steering. I?ve had it apart down to the bottom segment with the
28 ball bearings. I finally had time to get it back together to run
it today. I noticed that when turning it stop to stop, side to side
it turns well other then it feels like when cutting it to the left it
hits a little spot that seems somewhat rough momentarily. Also
it seems like it gets a little tougher to turn as it gets close to
the end of its turning radius side to side but I figure that is
probably where it relieves pressure. Also I noticed when
turning it seems to make somewhat of a squealing noise. Not
very much and nothing crazy, I?ve just noticed it. It?s almost
like the sound you hear when hydraulic oil is being pushed
through a relif valve. I just wondered if anybody had
experienced this and might have some insight into what I?ve
got going. Thank you.
steering. I?ve had it apart down to the bottom segment with the
28 ball bearings. I finally had time to get it back together to run
it today. I noticed that when turning it stop to stop, side to side
it turns well other then it feels like when cutting it to the left it
hits a little spot that seems somewhat rough momentarily. Also
it seems like it gets a little tougher to turn as it gets close to
the end of its turning radius side to side but I figure that is
probably where it relieves pressure. Also I noticed when
turning it seems to make somewhat of a squealing noise. Not
very much and nothing crazy, I?ve just noticed it. It?s almost
like the sound you hear when hydraulic oil is being pushed
through a relif valve. I just wondered if anybody had
experienced this and might have some insight into what I?ve
got going. Thank you.