PTO side cover

TinCan · Dec 1, 2018

I have read through my service manual and can't find any info about removing the PTO side cover.

I'm working on a '63 4000 diesel, with a SOS.

I need to replace the cover gasket, what do I need to watch out for when I remove it.

Is it not just a arm/lever that engages in a grove, or a step on the shaft, that moves something to connect the drive to the rear diff. Just a straight forward deal. I don't want to drop something, or mess anything up removing the cover.

Or am I totally wrong.

Thanks, Pat

TinCan · Dec 1, 2018

While I have the cover off, is there anything I should check out inside.

My good to needs repair ratio on this tractor isn't very good. So I'll most likely find something that need fixing in there!

Thanks, Pat

Larry NCKS · Dec 1, 2018

(reply to post at 07:35:40 12/01/18 )

Only 2 things.

1. You may need to drain some hydraulic oil.

2. When going back together, make sure you get the TDC eccentric back in the groove on the coupler.

TinCan · Dec 1, 2018

Thanks, I'm draining all fluids as I go. I'm cleaning inside as much as I can, and installing new oil when, I'm done pulling everything apart. When ever I get to that point!

Thanks, Pat

PTO side cover

TinCan

Member

TinCan

Member

Larry NCKS

Well-known Member

TinCan

Member

Similar threads