(800) 853-2651
SHOP NOW

Ford 515 Tractor

H

Hayman1958

Member
I am looking for some guidance in removing the oil pan. Does the front have to be split? If so any tips. It is a loader tractor. Thanks
 

There are two pivot pins for the axle. One goes through the bolster. The other goes through the pan.
You might? be able to pull both pins and drop the axle then raise the engine enough to clear the oil pump and get the pan out of there. You will need to remove the two studs that fasten the pan to the bolster. It probably would help to loosen the 4 upper engine to bolster bolts and slide the bolster forward 1/8" too.
 
You must log in or register to reply here.

Similar threads

M
8600 oil pan removal
Replies
8
Views
333
Brown David
Brown David
M
Seal kit needed for FoMoCo loader
Replies
6
Views
197
Andy Wickiser
A
W
WTB loader 19-124 for 1958 Ford 961-5 (Row Crop)
Replies
1
Views
74
showcrop
showcrop
M
Current restored Ford 861 value
Replies
18
Views
745
Tim PloughNman Daley RIP
T
H
Ford 515/4600 Transmission Fluid
Replies
1
Views
181
JoeM(GA)
JoeM(GA)
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top