|
| |
| Ford Tractors Discussion Forum |
601 front bushings
| Author |
[Modern View] |
|
BigDanT
03-31-2018 06:45:45
|
Needing to replace the front bushings on my 641, did a quick measurement and found that the lower bushing has a 1.5" (37.27mm) ID. All the parts sites I've checked show a part #nca3110 which has a 1.37" ID. I looked at the new Holland web site and they show a larger bushing but their # does not cross to anything I've been able to find (312662). Would anybody happen to have a number for that larger bushing? I've also checked Messicks and they show the larger bearing but not the bushing??? Thanks Dan
|
|
|
|
|
Sean in PA
03-31-2018 07:45:15
|
|
Re: 601 front bushings in reply to BigDanT, 03-31-2018 06:45:45
|
|
|
BigDanT
04-01-2018 06:49:42
|
|
Re: 601 front bushings in reply to Sean in PA, 03-31-2018 07:45:15
|
|
| |
After doing some more research I've found that the early 4000 uses the larger bushings too. This site sells them saying they replace part # nca3110B. $30 for a whole kit of lowers, uppers, seal and thrust bearings. I think I'll go this route. The tractor will live out the rest of it's life (OR MINE) on some recreation land and get very little use so as long as the bushings are close I'll be fine.
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
Needing good 70 series fenders. No rust or dents preferred.
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
